How to Easily Build a Dog Sled With Wheels

By Darlena Cunha

Making a dog cart from scratch can be onerous, time-consuming and very difficult. You would need intricate instruction manuals and many small parts. For those that are less handily inclined, using a preconstructed child's wagon can speed up the process and leave you with a sturdy, reliable sled that is on par with any you could buy or make yourself. The harness and braking system must be in place if you are to attempt this. Otherwise you could harm the dog and the passenger.

Step 1

Take the handle off of the child's wagon, leaving the hitch in place. Where the handle base slipped through the now-loosened hitch, thread the "U"-shaped aluminum conduit pole, starting on one side and moving your body with the pole so that you always have a firm and balanced grip on the metal. If the metal slips, your hitch will not retighten correctly and you could risk injury. Once the pole is in place, tighten the hitch as much as possible while holding the piping parallel to the ground. The piping should stay parallel.

Step 2

Tie a Prusik knot at the base of your "U"-shaped piping where the hitch to the wagon is. Fold your rope in half, and place the loop on one side of the bar so that it rests squarely over the hitch, flipping the ends over the top so that they drag down on the other side. Make sure the rope is at least 4 feet on either end. Thread the ends into the loop so that the rope is secured to the bar at the hitch. Thread the ends through the loop again to ensure tightness in the attachment. Then, pull the ends of the rope so that the knot does not slide. Having the hitch in the center of the knot will help keep it in place.

Step 3

Loop the rope once under the piping on each end so that when the rope is pulled on the piping will lift slightly, easing the weight on the dog even as the pull of the rope increases pressure. This will keep the forces at work on the dog equal at all times and prevent undue stress on its muscles as it brakes. Loop the rope into the wagon from underneath, giving you two reins.

Step 4

Slip the carting harness onto the dog. Place the ends of the piping into the harness on either side. The carting harness should be made for holding this piping and will have fitted pockets and tightening loops to secure them in place. The dog should now be able to pull the cart easily.

References

About the Author

Darlena Cunha has been a writer and editor since 2003. She has a Bachelor of Arts in journalism and a Bachelor of Science in biology from the University of Connecticut. Cunha is also completing her master's degree in mass communication.

Related Articles

More Related