Looking to Get in Shape or Lose Weight? Try our BMI and Weight Loss Calculator!

How to Adjust the Bindings on the Atomic 310 Ski

By Eric Cedric

Atomic makes and produces skis, bindings and boots. Atomic's 310 series of bindings come either as stand alone bindings to be mounted on your skis, or packaged with Atomic skis. Atomic made these bindings so you could adjust them without having to take them off the ski, drill new holes, and remount them. The range of adjustment on the bindings goes from 260 to 380 mm, giving a large range of ski boot sizes that fit the bindings. There is a DIN setting of 3-14 depending on the model of 310 used.

Place the skis with bindings down on a flat workbench or surface. Consult a DIN chart for your weight, ski ability and style (see Resources).

Turn the large set screw on the back of the binding to adjust the DIN setting. Turn the screw to the left to lower the DIN setting, and to the right to increase the DIN number. Find the DIN setting mark in the small dial off the set screw. Use the DIN setting off the chart to set your binding.

Place a ski boot into the ski binding and push it down to lock the binding. Check that the binding is firmly around the toe piece and the heel piece. Release the binding and remove the ski.

Pull the release adjustment lever up; the lever is found in the center of the binding. Push or pull out the front of the binding to reduce or increase the distance between heel and toe locks, depending on what you need for your boot size.

Push the lever down and check it locks back into the housing. Place the ski boot back into the binding to test the size adjustment. Adjust the other binding and ski in the same way.

Cite this Article A tool to create a citation to reference this article Cite this Article

More Related Articles

Related Articles